Thermogroup - 12Volt Matte Black Round Heated Ladder Rail
Thermogroup - 12Volt Matte Black Round Heated Ladder Rail

Thermogroup - 12Volt Matte Black Round Heated Ladder Rail

$659.00 $779.00
SKU: SR4412B
 
$659.00 $779.00you save $120.00
 

Heated Towel Rails are an affordable luxury for every bathroom for warming and drying your towels. The SR4412B Heated Towel Rail is a 600 x 800mm seven bar matte black ladder rail.

The SR4412B electric towel dryer is a 12v unit, this means that it can be installed close to a wet area in the bathroom. The rail comes supplied with a transformer which reduces the incoming voltage from 240v to 12v. The rail will still operate at the same temperature and use the same amount of electricity as an equivalent 240v rail as the wattage is the same, however, the rail is operating at a lower voltage.

The rail has a wiring point on both the left and right-hand side of the rail and can be wired at either the top or bottom of the rail. As it is a 12v unit and needs to be wired to a transformer the rail can only be hardwired.

The electric towel rail is designed to rapidly heat up and reach a temperature of around 45-55 degrees. The rail can be operated using an on/off switch however we recommend using a timer to allow you to set and forget and control your running costs. As the rail is electric it is very energy efficient and can cost as little as a $1 a week to run.

  • Product Code SR4412B
  • Output 100Watts
  • IP Rating IP55
  • Warranty 7yrs
  • Lead Length 5m
  • Voltage 12Volt
  • No of Bars 7
  • Wiring Type Concealed (hardwired)
  • Wiring Position Any of the four mounting positions
  • Distance Between Mounting Points (Top to Bottom) 600mm
  • Distance Between Mounting Points (Left to Right) 568mm

PLEASE NOTE: Specifications are for information purposes only. Whilst every effort has been made to ensure the product specifications are accurate, due to continuing product development and improvement the specifications are subject to change. Specifications can be used to rough in and fit timber supports in the wall however we recommend no holes are drilled without having the product on site or verifying the details with the manufacturer. Thermogroup cannot be held liable or responsible for errors due to updated specifications.